Dynojet 424x: Installation Guide - Manual (Page 167)

S T A T I O N A R Y D Y N O U P G R A D E
Deck Relocation
Version 8 Above Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
C-15
14 Secure the deck to each deck brace using two 3/8 x 1-inch bolts and two 3/8-inch
lock washers each. Make sure to use one 3/8-inch flat washer and one 3/8-inch nut
on the inside of each outer deck brace.
15 Tighten all deck brace hardware.
Figure C-14: Securing the Deck
I NSTALLING THE N EW S TYLE D ECK ON THE 4WD D YNO
Before installing the deck, make sure to complete the 4WD dyno and bridge
installation found in Chapter 3.
Refer to page 3-45 for deck installation instructions.
AD370
nut
flat washer
outer deck brace
lock washer
bolt