Dynojet 424x: Installation Guide User Manual
Page 55
4 W D D Y N O I N S T A L L A T I O N
Cable Routing
Version 8
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
3-17
W
IRING
THE
B
REAKOUT
B
OARD
—W
ITH
O
NE
E
DDY
C
URRENT
B
RAKE
1
Attach the pickup card cable (B, C) to the Breakout board. This cable may already
be connected.
The pickup card cable (B) from the stationary dyno has four wires which connect
to the wiring block labeled DRUM 1.
The pickup card cable (C) from the 4WD dyno has four wires which connect to
the wiring block labeled DRUM 2.
2
Attach the brake signal cable (D) to the Breakout board. The brake signal cable
from the 4WD dyno has two wires which connect to the wiring block labeled
BRAKE.
Note: There will already be wires connected to BRAKE; add the brake signal wires
to this location.
3
Attach the theta signal cable (L) cable to the Breakout board.
The theta signal cable (L) from the stationary dyno has five wires which connect to
the wiring block labeled LOAD CONTROL.
4
Attach the temperature sensor (N) cable to the Breakout board.
The temperature sensor cable (N) from the stationary dyno has five wires which
connect to the wiring block labeled TEMP.
5
Verify the jumpers are set as shown in Figure 3-10.
• Red wire connects to R1
• Black wire connects to B1
• White wire connects to W1
• Ground (shield) wire connects to S1
• Black wire connects to V-
• Red wire connects to V+
• White wire connects to O+
• Green wire connects to O-
• Ground (shield) wire connects to SH
• Green wire connects to GRN
• White wire connects to WHT
• Black wire connects to BLK
• Red wire connects to RED
• Ground (shield) wire connects to S1