Kontron TIGH2U Carrier Grade Server - Manual (Page 101)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
101

Server Component Replacements—TIGH2U Server
8. Open the bridge board connector latches. (“A”)
9. Lift the bridge board from the chassis (“B” and “C”)
Figure 79. Removing the Bridge Board
TS000435
B
C
A
Note: If you want to re-use components from this server board on the replacement board you
can remove them now or remove them after you lift the server board from the chassis.
• To remove an I/O expansion module or remote management module, see Section 4.3, “Installing
an I/O Expansion Module” on page 59 or Section 4.4, “Installing Remote Management Module 2
Components” on page 61 .
• To remove DIMMs, see Section 3.4.4, “Removing Memory DIMMs” on page 45 .
• To remove the heat sink(s) and processor(s), see Section 3.4.5.2, “Removing a Processor” on
page 47 .