Kontron TIGH2U Carrier Grade Server - Manual (Page 99)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
99

Server Component Replacements—TIGH2U Server
5.6.2 Installing the Power Distribution Board
1. Lower the replacement power distribution board (PDB) into place. ( Figure 78 , “A”)
2. Make sure that the PDB is placed over the placement pegs and push down until it clicks into place.
(“B”)
Figure 78. Installing the PDB
A
B
TS000439
3. Connect the five power supply connectors on the server board and the SFP board.
4. Install the drive bay assembly. For instructions, see
Section 5.5.4, “Installing the Drive Bay
Assembly” on page 96 .
5. Install the PCI riser card assembly. For instructions, see Section 4.2.5, “Installing the PCI Riser
Card Assembly” on page 59 .
6. Install the PCI fan assembly. For instructions, see Section 5.2.6, “Installing the Fan Assembly” on
page 82 .
7. Install the CPU fan assembly. For instructions, see Section 5.2.3, “Installing the CPU Fan
Assembly” on page 77 .
8. Install the processor air duct. For instructions, see Section 3.2.6, “Installing the Processor Air
Duct” on page 29 .
9. If this is the last task you are performing, replace the chassis top cover. For instructions, see
Section 3.2.4, “Installing the Chassis Cover” on page 27 .