Kontron TIGH2U Carrier Grade Server - Manual (Page 27)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
27

Server Component Installations and Upgrades—TIGH2U Server
4. Remove the shipping screw at the left side, near the rear.
5. While holding the blue button at the top of the chassis in (“A”), slide the top cover back until it
stops.
6. Lift the cover straight up to remove it from the server.
Figure 10. Removing the Chassis Cover
B
A
TS000422
3.2.4 Installing the Chassis Cover
1. Place the cover over the chassis so that the side edges of the cover sit just inside the chassis side
walls, with the front of the cover with about 1/8-inch (3-mm) gap showing between the chassis
cover and the sheet-metal at the front of the chassis.
2. Press down slightly on the chassis cover behind the peripheral area and slide the cover forward
until it clicks into place.
3. Install the shipping screw if tooled entry is required or if the system will be shipped.
4. Reconnect all peripheral devices and the power cord(s).
Caution: This unit must be operated with the top cover installed to ensure proper cooling.