Kontron TIGH2U Carrier Grade Server - Manual (Page 57)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
57

Optional Component Installations—TIGH2U Server
9. Determine your next steps and follow the appropriate procedures:
— Remove or install an add-in card. See Section 4.2.3, “Removing an Add-in Card from the Riser
Card Assembly” on page 57 or Section 4.2.4, “Installing an Add-in Card in the Riser Card
Assembly” on page 58 .
— If you are following these steps as part of another procedure, return to that procedure.
4.2.3 Removing an Add-in Card from the Riser Card Assembly
Caution: When handling an add-in card, observe normal safety and ESD precautions. See
Appendix A, “Safety Information” for more information.
1. Remove the PCI riser card assembly. For instructions, Section 4.2.2, “Removing the PCI Riser
Card Assembly” on page 56 .
2. Turn the riser card assembly upside-down.
3. Remove the rear retention screw that fastens the riser card to the rear bracket. (“A” or “D”)
4. When removing a full-height add-in card, remove the front retention clip by loosening the blue
captive screw and rotating the clip outward. (“B”)
5. Remove the add-in card from the riser card socket. (“C” or “E”)
6. Determine your next steps and follow the appropriate procedures:
— If you are installing a replacement add-in card, see Section 4.2.4, “Installing an Add-in Card
in the Riser Card Assembly” on page 58 .
— If you are ready to reassemble your system, see Section 4.2.5, “Installing the PCI Riser Card
Assembly” on page 59 .
Figure 37. Removing an Add-in Card from the Riser Card Assembly
Full-height Add-in Cards
TS000280
A
B
C
D
E