Kontron TIGH2U Carrier Grade Server - Manual (Page 46)

TIGH2U Server—Server Component Installations and Upgrades
Kontron Carrier Grade Server TIGH2U
Product Guide, rev.1.2 December 2009
46
5. Holding the DIMM by the edges, lift it from the socket, and store it in an anti-static package.
6. Replace the air duct and chassis cover if you have completed all work inside of the server.
3.4.5 Adding or Replacing a Processor
Note: Use the instructions provided below to add or replace a processor instead of using the
instructions that came with the processor.
Warning: Use only an approved processor. Otherwise, system damage may occur. For a list of
compatible processors see the Spares and Configuration Guide at
http://us.kontron.com/products/systems+and+platforms/
communication+rackmount+servers/ip+network+servers/
ip+network+server+tigh2u.html 
Click on downloads, and then Ordering Guide.
Before you begin, remove the processor air duct. For instructions, see Section 3.2.5, “Removing the
Processor Air Duct” on page 28 .
3.4.5.1 ESD and Processor Handling Precautions
Be mindful of the following points when handling the processors and sockets:
• To reduce the risk of electrostatic discharge (ESD) damage to the processor:
— Touch the metal chassis before touching the processor or server board.
— Keep part of your body in contact with the metal chassis to dissipate the static charge while
handling the processor.
— Avoid unnecessary movement.
— Use a ground strap attached to the front panel (with the bezel removed.)
• Do not touch the gold wires in the socket.
• Hold the processor only at the edges to avoid touching the gold contacts on the processor.
Figure 27. Cautions for Handling Processors