Kontron TIGH2U Carrier Grade Server - Manual (Page 47)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
47

Server Component Installations and Upgrades—TIGH2U Server
3.4.5.2 Removing a Processor
1. Loosen the four captive screws on the corners of the heat sink with a #2 Phillips screwdriver.
( Figure 28 , “A”)
2. Twist the heat sink slightly to break the seal between the heat sink and the processor. (“B”)
3. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink again.
Note: Do not force the heat sink from the processor. Doing so could damage the processor.
Figure 28. Removing the Heat Sink
TS000279
2
3
1
4
A
B
4. Open the socket by pushing the lever handle down and away from the socket to release it. (“A”
and “B” in Figure 29 )
Figure 29. Using the Socket Lever
A
B
AF000768