Kontron TIGH2U Carrier Grade Server - Manual (Page 53)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
53

Optional Component Installations—TIGH2U Server
4.1.3 Cable Routing Reference
It is important for cables to be connected correctly. See Figure 35 and for more detailed information
about cable connectors, see the Kontron Carrier Grade Server TIGH2U Technical Product
Specification.
Figure 35. System Cable Routing
4.2 Installing or Replacing a PCI Add-in Card
The Carrier Grade Server TIGH2U is delivered with a riser card assembly that includes the two riser
cards:
• A combination PCI-X*/PCI Express* (PCIe*) riser card for full-height add-in cards.
• A PCIe riser card with two slots for low-profile add-in cards
The riser card assembly is attached to the server board by two connectors in the middle of the server
board. (See Figure 7 on page 19 for these locations.)
Note: PCI-X/PCI Express add-in cards are referred to generically as “add-in cards” in the
following procedures.