Kontron TIGH2U Carrier Grade Server - Manual (Page 26)

TIGH2U Server—Server Component Installations and Upgrades
Kontron Carrier Grade Server TIGH2U
Product Guide, rev.1.2 December 2009
26
Note: The front bezel can be removed while the server power is on.
1. Disconnect the cables from the front panel USB port and / or serial port connectors.
2. Loosen the bezel retention screw from the right side. (“A”)
3. Rotate the bezel outward as shown and remove. (“B”)
Figure 9. Removing the Front Bezel
TS000423
A
B
3.2.2 Installing the Front Bezel
1. Align the four tabs on the left side of the bezel with the slots in the front panel and then rotate the
free end of the bezel to the closed position.
2. Snap the front bezel into place and tighten the screw at the right edge of the bezel (if used).
3. Re-connect the serial port and USB cables if they are used.
3.2.3 Removing the Chassis Cover
The TIGH2U Server must be operated with the top cover in place to ensure proper cooling. You will
need to remove the top cover to add or replace components inside of the server that are not hot-
swappable from the front or rear panels.
Caution: 5 V standby power is present inside the chassis whenever the PSU(s) are connected to
a source of power.
Before removing the top cover, power down the server system and unplug all peripheral devices and
the power cable.
Note: A non-skid surface or a stop behind the server may be needed to prevent the server
from sliding on your work surface.
1. Observe the safety and ESD precautions in Appendix A, “Safety Information” .
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the power cord(s).