Kontron TIGH2U Carrier Grade Server - Manual (Page 25)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
25

Server Component Installations and Upgrades—TIGH2U Server
3 Server Component Installations and Upgrades
3.1 Before You Begin
Before working with your server product, pay close attention to the safety instructions provided in this
manual. See Appendix A, “Safety Information” .
Warning: Electrostatic discharge (ESD) and ESD protection: ESD can damage disk drives,
boards, and other parts. Perform the procedures in this chapter at an ESD workstation.
If one is not available, provide some ESD protection by wearing an antistatic wrist strap
attached to chassis ground (any unpainted metal surface) on your server when
handling parts.
3.1.1 Tools and Supplies Needed
• #1 and #2 Phillips (cross-point) screwdrivers (or interchangeable tip screwdriver with #1 and #2
Phillips bits)
• Personal grounding device such as an anti-static wrist strap and a grounded conductive pad
3.1.2 System References
All references to left, right, front, top, and bottom assume that you are facing the front of the server,
as it would be positioned for normal operation.
3.2 General Installation Procedures
The following sections present general installation and removal procedures that are required before
removing or installing internal components that are not hot-swappable.
3.2.1 Removing the Front Bezel
Remove the front bezel to
• Install or remove hard drives or an optical device
• Access the front-panel serial port and USB connectors
• Observe the individual HDD activity/fault indicators
• Install or remove the optional Intel
® RAID Smart Battery