Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.3 - Manual (Page 32)

26 Counterpart User Manual
Level 5 submenus - Format
PRIMRY UNITS
DECPNT
DSPDIV Allows you to set the primary units, decimal point format, and display divisions.
SEC KG
G
LB
OZ
OFF Allows you to set the secondary units.

Decimal point format and display divisions are selected automatically. Values are
kg=kilogram (default); g=gram; lb=pound; oz=ounce; and off.
Note
If using the <cu> token and secondary or tertiary values are changed,
the stream tokens must be changed to match in order to stream
secondary or tertiary.
TER OFF
KG
G
LB
OZ Allows you to set the tertiary units.

Decimal point format and display divisions are selected automatically. Values are off
(default); kg=kilogram; g=gram; lb=pound; oz=ounce.
Note
If using the <cu> token and secondary or tertiary values are changed,
the stream tokens must be changed to match in order to stream
secondary or tertiary.
Level 5 submenus - Calibration
WZERO Allows you to view or change the zero calibration a/d count value.
WVAL Allows you to view and edit the test weight value.
WSPAN Allows you to view or change the span calibration a/d count value.
WLIN POINT 1
POINT 2
POINT 3
POINT 4
POINT 5 Press ENTER to display and edit test weight and calibration values for up to five
linearization points. Perform linear calibration only after WZERO and WSPAN have been set.
Parameters include CAL1 - View or change linear point calibration value.
WGT1 - Sets test value.
REZERO Removes offset from zero and span calibrations. Can be used during a span calibration
process using hooks and chains.
Level 6 submenus - Primary, Secondary, Tertiary
UNITS LB
OZ
KG
G
OFF Specifies primary units for displayed and printed weight. Values are lb=pound; oz=ounce;
kg=kilogram; g=gram.
DECPNT 8888800
8888880
8888888
8.888888
88.88888
888.8888
8888.888
88888.88
888888.8 Allows you to place the decimal point position. Use the ID ( ) and TARGET ( ) keys to
place the decimal point where desired.
DSPDIV 1D
2D
5D Display divisions. Selects the minimum division size for the primary unit’s displayed weight.
SETUP Menu
Parameter Choices Description
Table 3-3. Setup Menu Parameters (Continued)