Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.3 - Manual (Page 50)

44 Counterpart User Manual
Setpoints Weigh Mode Parameter Menu
Set up of setpoints is allowed while in the weigh mode.
While setting up setpoints, the Access parameter needs to be set to either On or Off.
• Setting it to On allows a setpoint to be viewed and edited if setpoint type is: Gross, Net, Piececnt, %Rel,
Delay or Counter.
• Setting it to Off allows a setpoint to be viewed but not edited if the setpoint type is: Gross, Net, Piececnt,
%Rel, Delay, or Counter.
• Hide will not show the setpoint.
XXXXXXX ID DISPLAY TEST SETUP AUDIT CALIBR
VALUE BANDVAL
If TRIP=
INBAND or
OUTBAND
number number
HYSTER
number
PRESTAB PCOUNT
VALUE
PREVAL
number
PREADJ
number
FMT
Level 1
Level 2 SETPT 1 SETPT 2 - SETPT 6
SAME AS SETPT 1
GROSS NET PIECECNT DELAY %REL COUNTER
In Weigh Mode
If TRIP=
HIGHER or
LOWER
If PREACT=
ON or
LEARN
If PREACT
=
LEARN
number
SETPTS
VALUE
number
Figure 3-12. Setpoint Menu While in Weighmode