Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.3 - Manual (Page 43)

Counterpart User Manual - Configuration 37
SETUP Menu
Parameter Choices Description
Level 2 submenus
SCALE See Section 3.6.1 on page 22 Configure scale settings. See the level 3 submenus of Table 3-3 on page 24 for
parameter descriptions.
FEATURE See Section 3.6.3 on page 28 Set counting options, region settings, view Unit ID, and set consecutive
numbering. See level 3 submenus of Table 3-5 on page 29 for parameter
descriptions.
SERIAL PORT 1
PORT 2
PORT 3 (Option Card) Configure communications ports. See level 3 submenus below for parameter
descriptions.
ETHERNET DHCP
IPADDRES
NETMASK
DFLTGTWY
DNSPRI
DNSSEC
LCLHSTNM
PORT
REMOTEIP
REMOTEPT
MAC
VAULT
ECHO DHCP = on/off for static
IP ADDRES = Address leased or statically set
NET MASK = sub net address
DFLTGTWY = default gateway
DNSPRI = primary domain server IP number
DNSSEC = secondary domain server IP number
COUNTERPART= local host name
PORT = port number used
REMOTE IP = remote IP number using Weighvault
REMOTE PT = remote port number using Weighvault
MAC = views the MAC address and is non-changeable
VAULT = on or off
ECHO = on or off
PFORMT GFMT
NFMT
CFMT
PALFMT
ACCFMT
TOTALFMT
SPFMT
SetptFMT
HDRFMT1
HDRFMT 2 Sets the print format for gross weight mode, net weight mode, count, pallet,
accumulate, total, setpoint, header 1 and header 2.
SETPTS SP CFG BATCHING See Figure 3-11 on page 40 and Table 3-8 on page 41 for parameters.
DIG IO DIO 1
DIO 2
DIO 3
DIO 4 Assign digital input/output functions.
VERS SOFTWR
REG Displays the software version.

Displays the regulatory version.
Level 3 submenus - Under the Level 2 Serial Feature
PORT 1
PORT 2
PORT 3 CMD
SCANNER
SCALE
IND SCALE
KEYBOARD Specifies Port 1 through 3’s mechanism for triggering a transmission of data, print
message, baud rate, bits, stop bits, termination character, end-of-line delay, and
echo. see level 4 submenu for parameter descriptions.
Table 3-7. Serial, PFORMT, DIG I/O, VERS submenu parameters