Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.3 - Manual (Page 61)

Counterpart User Manual - Scale Operations 55
Counting Out of a Full Container - See Total Amount Remaining in the Container
To carry out this operation you must know the tare weight ahead of time.
1. Place the full container on the scale. Press the TARE key.
2. Remove a 10 piece sample to the container and press the SAMPLE key. After the unit weight has been
calculated, return the 10 piece sample to the container.
3. If you want to see how many are still in the bin you first have to know the tare weight of the bin or
container. After removing the parts you want to take out of the bin, simply digitally enter the tare weight
of the bin and press the
TARE key. The scale will display how many parts were left in the bin. To print a
label to put on the bin showing the total quantity in the bin, press the PRINT key.
Negative Counting - Total Removed Displayed at the End
With this procedure you can count accurately out of a full container for kitting, shipping, etc.without having to
know the tare weight of the container.
1. Place a full container on the scale and press TARE .
2. Remove a 10 piece sample from the container and press SAMPLE . After the unit weight has been
calculated, return the 10 piece sample to the container.
3. Remove the number of pieces you need for kitting, shipping, etc. The amount removed will be displayed.
If you need a label for each kit or container, press the PRINT key after removing each batch of pieces.
5.5 IDs
IDs are used to save and recall previously set codes, descriptions, unit weight, and tare preferences. The
Counterpart has the capacity to store up to 150 individual IDs. There are three ways that IDs can be entered and
set. Those three ways include:
1. Normal
2. Through Count Mode
3. Through Revolution
To enter alpha ID characters you can double press the numeric keypad to obtain alpha characters much like
accessing alpha characters on a cell phone keypad.
To store more than 150 IDs, WeighVault is required (see Section 5.6 on page 58).
REG 1 REG 2
QUANTITY
SAME AS REG 1
CODE DESC PART NUM LOT UNIT WT TARE
VALUE VALUE VALUE LB
G
KG
OZ
OFF
UNITS LOCATION
XXXXXXX ID DISPLAY TEST SETUP AUDIT CALIBR
REG 150
SAME AS REG 1
VALUE VALUE VALUE VALUE VALUE
SETPTS
Figure 5-1. ID Menu
5.5.1 Setting an ID Using the Normal Mode
1. Press the MENU SETUP key MENU
SETUP
to access this menu.
2. Press to ID and then press and you will be at REG1.
3. Navigate to the REG number you want to set (1-150) by using the and keys.
Note
All menus have wrap-around functionality. If you are at ID1 and want to access ID150, you can quickly do so
by moving backwards through the menu.