Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.3 - Manual (Page 49)

Counterpart User Manual - Configuration 43
BATCH Off
On Specifies whether the setpoint is used as a batch (ON) or continuous (OFF) setpoint.
PSHACCM Off
On
ONquiet Specifiy ON to update the accumulator and perform a print operatoin when the setpoint is
satisfied. Specify ONQUIET to update the accumulator without printing.
PSHPRNT Off
On
Waitss Specify ON to perform a print operation when the setpoint is satisfied; specify WAITSS to
wait for standstill after setpoint is satisfied before printing.
PSHTARE Off
On Specify ON to perform an acquire tare operation when the setpoint is satisfied. Note that
PSHTARE acquires the tare regardless of the value specified for the REGULAT parameter
on the FEATURE menu.
ACCESS On
Hide
Off Specifies the access allowed to setpoing parameters shown by pressing the Setpoint
softkey in normal mode.
ON: Values can be displayed and changed.
HIDE: Values cannot be displayed or changed.
OFF: Values can be displayed but not changed.
DIGOUT None
1-4 Lists all digital output bits available. This parameter is used to specify the digital output bit
associated with this setpoint. Use the DIGI/O menu to assign bit function to OUTPUT. For
continuous setpoints, the digital output becomes active (low) when the condition is met;
for batch setpoints, the digital output is active until the setpoint condition is met.
SENSE Normal
Invert Specifies whether the value of the digital output associated with this setpoint is inverted
when the setpoint is satisified.
Table 3-8. Setpoints Menu Parameters