8 parts reduction counts, 9 accumulate feature for weight, 1 printing the accumulated total – Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.3 User Manual
Page 67: 2 clearing the accumulated total, Printing the accumulated total, Clearing the accumulated total
Counterpart User Manual - Scale Operations
61
5.8
Parts Reduction Counts
Parts reduction can also be done by using the - key while the scale is in the weighing mode and the memory
annunciator is on.
1. Conduct a sampling process to determine the unit weight of the pieces. Or key in a known weight or
recall an ID.
2. Enter known tare weight, or place an empty container on the scale to perform tare function. If ID was
recalled in step one its tare value is already loaded.
3. Place container (full of parts) on the scale. The number of pieces in the container is shown in the
”PCS”
area of the display.
4. Press the
Total +
softkey to store the number of pieces in the container. The memory (
M
) icon is shown.
The net weight of the items in the container is stored and the totalization count is incremented. The total
piece count value is shown in place of the piece weight value and will be labeled
”ttl”.
The total net weight
is shown in place of the normal ID Code: line - it is labeled as Total Weight.
5. Remove the number of parts required from the container and press the
Total -
softkey. The total piece
count value is now equal to the number of pieces removed. The number of pieces remaining in the
container is shown in the
Pcs
area of the display. The total weight is now equal to the weight of the
removed pieces.
6. Repeat step 5 as needed.
Note
Once part reduction has been started, a press of Total + will give you an error message.
5.9
Accumulate Feature For Weight
The accumulate feature allows a weight value to be accumulated. Use the following steps to use this feature.
1. Enable the Accumulate in the Scale Menu. Press the
On
key and the display will say
Accumulator Enabled.
2. Set up the
Display Accum
-
(DSP ACC)
and
Swap Display (SWAPDSP)
softkey. Refer to Section 1.7 of the
manual for help on setting up softkeys.
3. The weight must be active on the display.
4. Each time there is a print, the weight value is added to the accum register and keeps track of how many
accums were completed. Product must be removed from the platform and the display returned to zero
each time this is done.
5.9.1
Printing the Accumulated Total
Press the
key to print the accumulated total when the Accum Value is displayed.
5.9.2
Clearing the Accumulated Total
1. Push the
CLR
softkey when the display Accum has been pressed.
2.
PRESS CLEAR TO VERIFY
, is displayed. Press
CLR
again to clear the accum value.