Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.3 - Manual (Page 75)

Counterpart User Manual - Serial Commands 69
6.1.6 Normal Mode Commands
The normal mode print commands (see Table 6-12) transmit data to the serial port on demand in either setup or
normal mode.
Table 6-12. Normal Mode Serial Commands
Command Description Values
CONSNUM#n Set consecutive number nnnnnnn
UID Set unit ID UID=nnnnnnn
SX#n Start serial port streaming OK or ??
An EX command sent while in menu mode does not take effect until the
indicator is returned to normal mode.
The EDP.Stream must be set to LFT or INDUST for this command to work.
EX#n Stop serial port streaming
XG#n Transmit gross weight in displayed units nnnnnn UU

where nnnnnn is the weight value, UU is the units.
NOTE: You can also send XGP, XGS, XGT, XTP, etc. to specify primary,
secondary or tertiary (P.S.T.).
XN#n Transmit net weight in displayed units
XT#n Transmit tare weight in displayed units
XA#n Transmit accumulator value
RS Reset system Soft reset. Used to reset the indicator without resetting the configuration to the
factory defaults.
SD Set date SD=MMDDYY, DDMMYY, YYMMDD, or YYDDMM. Enter six-digit date using
the year-month-day order specified for the DATEFMT parameter, using only the
last two digits of the year.
ST Set time ST=hhmm (enter using 24-hour format)
KSOFT1-4 Command to perform function assigned
to softkey. n/a
PIECES#n Transmits data from the scale n/a
6.1.7 Unique Commands
Table 6-13. Unique Commands
Command Description
DUMPID.INDEX=n To dump an ID by register
DUMPID.CODE=n To dump an ID by code
KDISPMODE Set or request the current display mode. KDISP=COUNT. Will switch to that mode. This only temporariliy
switches display. Default is set by dispmode parameter.
Other choices include:
COUNT
WEIGHT
UNIT WEIGHT