Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.3 - Manual (Page 63)

Counterpart User Manual - Scale Operations 57
5.5.4 Adding an ID From Count Mode
1. Press the CODE softkey.
2. Add in the ID number.
3. If the ID number is not already in the database, Counterpart prompts, Not Found, Save as New ID ?
4. Select Yes or No. By selecting Yes, Counterpart will store that ID code into the first open register. By
selecting No, you will go back to the Counting mode screen.
5. Optional - Sample Quantity desired and press the UW Update softkey.
6. Optional - Tare the container and push the Tare Update softkey.
5.5.5 Adding an ID Through Revolution
To add an ID using Revolution, you must have Revolution installed on your computer. Visit www.ricelake.com
to download this free configuration software.
1. Unplug power to Counterpart.
2. Wire cable between computer and Counterpart.
3. Plug in power to Counterpart and press Counterpart’s POWER key.
4. Open Revolution on computer and go to Base Configuration, >> IDs
5. To upload IDs from Counterpart, select Connect from the Toolbar or under Communications - Connect .
6. Select Communications then Upload Configuration or Upload Section.
7. Select REG # and add information into the screens as shown in Figure 5-2.
Figure 5-2. Adding IDs Through Revolution
8. To download the ID to Counterpart, connect if Revolution is disconnected, and select Communications and
either Download Configuration or Download Section.
9. All register IDs are now entered and available through Revolution.
Note
By Uploading ID’s using Revolution and saving them to a file the ID’s can be backed up for future use.