Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.3 - Manual (Page 65)

Counterpart User Manual - Scale Operations 59
Counterpart Setup for WeighVault
1. On the Counterpart, enter configuration mode (see Section 3.0 on page 19) and navigate to Setup »
Config » Ethernet.
AUDIT CALIBR SETUP TEST DISPLAY ID
SCALES FEATURE SERIAL ETHERNET PFORMT
CONFIG
VERS DIGIO SETPTS
SETPTS
DHCP IPADDRESS NETMASK DFLGTWY DNSPRI DNSSEC LCLHSTNM PORT
MAC REMOTEPT REMOTEIP VAULT
OFF
ONBOARD
EXTERNAL
ON
OFF
ECHO
OFF
ON
COUNTERPART
Figure 5-3. Ethernet menu
2. Set the DHCP parameter to OFF .
3. Set the IP address. In this example, we will use 192.168.0.1 , which is in the same range as the PC, but the
last digit is different. Check with your network administrator when setting an IP address for your system.
4. Set the NETMASK parameter (subnet mask) to 255.255.255.0 .

There are no changes needed to the DFLGTWY, DNSPRI, DNSSEC, and LCLHSTM parameters.
5. Set the PORT parameter to 10001 .
6. Set the REMOTEIP parameter (remote IP address) to 192.168.0.02 . This is the same IP address assigned
to the PC.
7. Set the REMOTEPT parameter (remote port) to 5466 .
8. Set the VAULT parameter to ONBOARD .
9. On the Counterpart, set up the Code softkey which enables quick access to ID codes.
5.6.2 Using Weighvault
Once the above criteria have been met, IDs can then be entered into WeighVault and saved on the PC. The Edit
Part dialog box in Figure 5-4 shows ID parameters which can be saved in WeighVault. For testing purposes,
enter a few part numbers and click on
Save Changes to Database .
Figure 5-4. WeighVault Edit Product Dialog Box
To access a saved ID from WeighVault over the network connection,
1. Using the Counterpart front panel, press the CODE key.
2. Enter an ID CODE value.
3. Press the TARE(Enter) key. The ID CODE is loaded and ready to use.
Note
If the demo feature is complete and not being used permanently with WeighVault, go the your network
settings and turn off the Assign IP Address feature.