Rice Lake MSI-9850 CellScale RF Digital Indicator - Operator Manual - Manual (Page 43)

MSI CellScale ® System • 9850 User Guide Page 43
MEASUREMENT SYSTEMS INTERNATIONAL
Firmware Version 5-XX for 2450 Modems
CONTENTION CONSIDERATIONS
It is important to understand that only one transmitter at a time can be activated within a reception area. While
the transmitted signal consists of encoded digital data, only one carrier of any frequency can occupy airspace
without contention at any given time.
RF REMOTE CONTROL FCC STATEMENT
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect
the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer
or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a Class B computing device, pursuant to FCC
Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment.
Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV
reception. The user is cautioned that changes and modifications made to the equipment without the approval of
manufacturer could void the user’s authority to operate this equipment
BATTERY REPLACEMENT
The remote unit utilizes a CR-2032 Button Lithium Cell. In normal use it
will provide 1-2 years of operation. Access for replacement is accomplished
by removing the battery access cover by pressing down firmly on the label
area and sliding it off. Once the unit is open, remove the battery by sliding it
from beneath the holder. Replace the cell with the same type while observ-
ing the polarity shown.
Go to Index