CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 104)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 104 of 350
DUT#configure terminal Enter configuration commands, one
per line. End with CNTL/Z
DUT(config)#interface eth-0-1 Enter the interface mode
DUT(config-if)#arp timeout 1200 Assign arp age timeout value to
interface eth-0-1
DUT(config-if)#arp retry-interval 2 Assign arp request retry delay
value to interface eth-0-1
14.1.2 Validation commands
1 verify the arp entries
DUT#show ip arp
Protocol Address Age (min) Hardware Addr Interface
Internet 11.11.11.1 - 48c9.86ab.6b00 eth-0-1
Internet 11.11.11.2 - 001a.a011.eca2 eth-0-1
Internet 11.11.11.3 0 001a.a011.eca3 eth-0-1
DUT1#show ip arp summary
3 IP ARP entries, with 0 of them incomplete
2 verify the arp request retry delay time and age period on interface eth-0-1
DUT#show interface eth-0-1
Interface eth-0-1
Interface current state: UP
Hardware is Ethernet, address is 48c9.86ab.6b00 (bia 48c9.86ab.6b00)
Bandwidth 1000000 kbits
Index 106 , Metric 1 , Encapsulation ARPA
Speed - 1000Mb/s , Duplex - Full , Media type is 1000BASE_T
Link speed type is autonegotiation, Link duplex type is autonegotiation
Input flow-control is off, output flow-control is off
The Maximum Frame Size is 1534 bytes
VRF binding: not bound
Label switching is enabled with label-space 0
minimum label value configured is 16
maximum label value configured is 1048575
No virtual circuit configured
VRRP master of : VRRP is not configured on this interface
ARP timeout 00:20:00, ARP retry interval 2s
Internet primary address: