CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 188)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 188 of 350
DUT(config-if)#ip pim dr-priority 10 Configure the interface (eth-0-1) as DR
DUT(config-if)#ip pim unicast-bsm Enable sending and receiving of Unicast
BSM for backward compatibility.
Validation Commands
1. Verify the C-BSR state on rtr1.
DUT#show ip pim sparse-mode bsr-router
PIMv2 Bootstrap information
This system is the Bootstrap Router (BSR)
BSR address: 20.0.1.21
Uptime: 00:37:12, BSR Priority: 64, Hash mask length: 10
Next bootstrap message in 00:00:04
Role: Candidate BSR
State: Elected BSR
2. Verify the C-BSR state on rtr2.
The initial state of C-BSR is P-BSR before transitioning to C-BSR.
DUT#show ip pim sparse-mode bsr-router
PIMv2 Bootstrap information
BSR address: 20.0.1.21
Uptime: 00:02:39, BSR Priority: 64, Hash mask length: 10
Expires: 00:00:03
Role: Candidate BSR
State: Pending BSR
DUT#show ip pim sparse-mode bsr-router
PIMv2 Bootstrap information
BSR address: 20.0.1.21
Uptime: 00:40:20, BSR Priority: 64, Hash mask length: 10
Expires: 00:02:07
Role: Candidate BSR
State: Candidate BSR
3. Verify RP-set information on E-BSR.
DUT#sh ip pim sparse-mode rp mapping
PIM Group-to-RP Mappings
This system is the Bootstrap Router (v2)
Group(s): 224.0.0.0/4
RP: 20.0.1.11
Info source: 20.0.1.11, via bootstrap, priority 0