CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 196)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 196 of 350
DUT1(config-router-af)#exit-address-family
DUT1(config-router-af)#redistribute connected
DUT1(config-router-af)#end
Display Results
Switch A output
(1) Check the route on Switch A
DUT1#show ip route
Codes: K - kernel, C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
[*] - [AD/Metric]
* - candidate default
C 1.1.1.0/24 is directly connected, eth-0-13
R 2.2.2.0/24 [120/2] via 1.1.1.2, eth-0-13, 00:05:11
C 3.3.3.0/24 is directly connected, eth-0-1
R 4.4.4.0/24 [120/3] via 1.1.1.2, eth-0-13, 00:04:40
K 192.168.100.0/24 is kernel directly connected, management interface
(2) Ping Switch B
DUT1#ping 4.4.4.1
PING 4.4.4.1 (4.4.4.1) 56(84) bytes of data.
64 bytes from 4.4.4.1: icmp_seq=0 ttl=63 time=265 ms
64 bytes from 4.4.4.1: icmp_seq=1 ttl=63 time=240 ms
64 bytes from 4.4.4.1: icmp_seq=2 ttl=63 time=261 ms
64 bytes from 4.4.4.1: icmp_seq=3 ttl=63 time=251 ms
64 bytes from 4.4.4.1: icmp_seq=4 ttl=63 time=217 ms
--- 4.4.4.1 ping statistics ---