CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 68)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 68 of 350
DUT(config) # erps 1 Create erps domain with id 1.
DUT(config) # erps 1 sub control vlan 12 Set vlan 12 as the sub control vlan of erps domain 1.
DUT(config) # erps 1 ring 2 level sub Create an erps sub ring 2 for domain 1.
DUT(config) # erps 1 ring 2 mode master Set node as master of ring 2 for domain 1.
DUT(config) # erps 1 ring 2 primary interface eth-0-9 Set primary interface of ring 2 for domain 1.
DUT(config)# erps 1 ring 2 secondary interface eth-0-13 Set secondary interface of ring 2 for domain 1.
DUT(config) # erps 1 ring 2 enable Enable ring 2 for domain 1.
DUT(config) # erps 1 enable Enable domain 1.
Validation Command
Switch 1
DUT #show erps 1
ERPS domain ID: 1
ERPS domain name: ERPS001
ERPS domain primary control VLAN ID: 11
ERPS domain sub control VLAN ID: 12
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 3 second(s)
ERPS ring ID: 1
ERPS ring level: primary
ERPS ring 1 node mode: master
ERPS ring 1 node state: complete
ERPS ring 1 primary interface name: eth-0-9
ERPS ring 1 secondary interface name: eth-0-13
Switch 2
DUT #show erps 1
ERPS domain ID: 1
ERPS domain name: ERPS001
ERPS domain primary control VLAN ID: 11
ERPS domain sub control VLAN ID: 12
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 3 second(s)
ERPS ring ID: 1
ERPS ring level: primary
ERPS ring 1 node mode: transit
ERPS ring 1 node state: link up