CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 250)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 250 of 350
30.2
Validating an Layer 2 FEC by Using MPLS LSP Ping and
MPLS LSP Traceroute:
30.2.1 Configurations on PE1
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# interface eth-0-12 Enter the Interface mode.
• eth-0-12—Specify the
interface
DUT1(config-if)# no switchport Configure the port to layer
3 port.
DUT1(config-if)# enable-ldp Configure Interface for
LDP
DUT1(config-if)# ip address 2.2.2.1/24 Create IP address on the
port.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)#interface loopback 0 Enter the Interface mode.
• loopback0—Specify the
loopback interface name.
DUT1(config-if)#ip address
10.10.10.10/32 Create loopback addresses
on both PE routers. Use a
/32 host route for the
loopback address.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)# targeted-peer
11.11.11.11 Configure Targeted Peer in
LDP.
DUT1(config-router)# transport-address
10.10.10.10 Configure Transport
Address in LDP.
DUT1(config-router)# exit Exit the router-ldp mode.
DUT1(config)#mpls l2-circuit vc1 100
11.11.11.11 Create a Virtual
Circuit.Both PE routers
must be configured with
the same VC-ID.