CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 170)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 170 of 350
22.2.4 Configuring IGMP Snooping mrouter port
An IGMP Snooping mrouter port is a switch port which is assumed to connect a multicast router.
The mrouter port is configured on the vlan. All the igmp queries received on this port will be
flooded on the belonged vlan. All the igmp reports and leaves received on this vlan will be
forwarded to the mrouter port, directly or aggregated, depending on the report-suppression
configuration. In addition, all the multicast traffic on this vlan will be forwarded to this mrouter
port.
DUT>enable Enter Privilege Exec mode
DUT#configure terminal Enter Configuration mode
DUT(config)# ip igmp snooping report-suppression Enable igmp snooping report
suppression globally
DUT(config)# ip igmp snooping vlan 1 mrouter interface eth-0-1 Configure mrouter port on vlan 1
DUT(config)# ip igmp snooping vlan 1 report-suppression Enable igmp snooping report
suppression on vlan 1
22.2.5 Validation Commands
Display IGMP Snooping Configuration
DUT#show ip igmp snooping
Global Igmp Snooping Configuration
-------------------------------------------------
Igmp Snooping :Enabled
Igmp Snooping Fast-Leave :Disabled
Igmp Snooping Version :2
Igmp Snooping Max-Member-Number :4096
Igmp Snooping Unknown Multicast Behavior :Flood
Igmp Snooping Report-Suppression :Enabled
Vlan 1
-----------
Igmp Snooping :Enabled
Igmp Snooping Fast-Leave :Disabled
Igmp Snooping Report-Suppression :Enabled
Igmp Snooping Version :2
Igmp Snooping Max-Member-Number :4096
Igmp Snooping Unknown Multicast Behavior :Flood
Igmp Snooping Group Access-list :N/A
Igmp Snooping Mrouter Port :eth-0-1