CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 200)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 200 of 350
--- 4.4.4.1 ping statistics ---
5 packets transmitted, 5 received, 0% packet loss, time 4050ms
rtt min/avg/max/mdev = 111.250/118.414/123.779/4.920 ms, pipe 2
DUT1#ping vrf vpn2 1.1.1.1
PING 1.1.1.1 (1.1.1.1) 56(84) bytes of data.
64 bytes from 1.1.1.1: icmp_seq=0 ttl=64 time=117 ms
64 bytes from 1.1.1.1: icmp_seq=1 ttl=64 time=115 ms
64 bytes from 1.1.1.1: icmp_seq=2 ttl=64 time=144 ms
64 bytes from 1.1.1.1: icmp_seq=3 ttl=64 time=141 ms
64 bytes from 1.1.1.1: icmp_seq=4 ttl=64 time=137 ms
--- 1.1.1.1 ping statistics ---
5 packets transmitted, 5 received, 0% packet loss, time 4057ms
rtt min/avg/max/mdev = 115.059/131.204/144.576/12.363 ms, pipe 2
DUT1#ping vrf vpn2 4.4.4.1
connect: Network is unreachable
25.2.2 Topology2
The connection between CE and PE are use VLAN trunk link. This link allows traffic from the
CE router to the PE router to be segmented into each separate VRF.
In generally, the CE router associates a specific VRF by the clients connected to its interfaces
and exchanges that information with the PE router. Routes are installed in the VRF on the
VRF-lite CE. There also needs to be a routing protocol or a static route that propagates routes
from a specific VRF on the VRF-lite router to the same VRF on the PE router. In the following
example we use RIP to propagates routes between CE and PE.