CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 258)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 258 of 350
11.11.11.11 send-community both attribute should be sent to a
BGP neighbor.
DUT1(config-router-af)#exit-address-family Exit the address family
mode.
DUT1(config-router)#address-family ipv4 Enter the IPv4
address-family command
mode.
DUT1(config-router-af)#neighbor
11.11.11.11 activate Enable the exchange of the
specified AF routes with a
neighboring router.
DUT1(config-router-af)#neighbor
11.11.11.11 send-community both Specify that a community
attribute should be sent to a
BGP neighbor.
DUT1(config-router-af)#redistribute
connected Redistribute connected
routes in the VRF
DUT1(config-router-af)#redistribute static Redistribute static routes in
the VRF
DUT1(config-router-af)#exit-address-family Exit the address family
mode.
DUT1(config-router)#address-family ipv4
vrf vpn1 Enter the IPv4
address-family command
mode.
DUT1(config-router-af)#redistribute
connected Redistribute connected
routes in the VRF
30.3.2 Configurations on PE2
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface
eth-0-12 Enter the Interface mode.
• eth-0-12—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#enable-ldp Configure Interface for LDP
DUT1(config-if)#ip address
2.2.2.2/24 Create IP address on the port.