CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 36)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 36 of 350
5.4.1 Topology
5.4.2 Configurations
Bridge 1
DUT#configure terminal Enter the Configure mode.
DUT(config)#vlan database Enter the VLAN database mode.
DUT(config-vlan)#vlan 10,20 Create VLAN 10,20
DUT(config-vlan)#exit Exit VLAN database mode.
DUT(config)#interface eth-0-1 Enter the interface mode.
DUT(config-if)#switchport mode trunk Set the switching characteristics of this interface trunk
mode.
DUT(config-if)#switchport trunk allowed vlan all Set this trunk allow all VLANs on this interface.
DUT(config-if)#switchport trunk native vlan 10 Set this trunk port’s PVID to 10.
DUT(config)#interface eth-0-2 Enter the interface mode.
DUT(config-if)#switchport mode access Set the switching characteristics of this interface access
mode.
DUT(config-if)#switchport access vlan 10 Enable VLAN port access by specifying the VLAN ID 2
on this interface.
DUT(config-if)#end Exit to exec mode.
DUT#show vlan brief Display vlan’s configurations.
DUT#show interface switchport Display interface’s switch configurations.
Bridge 2
DUT#configure terminal Enter the Configure mode.
DUT(config)#vlan database Enter the VLAN database mode.
DUT(config-vlan)#vlan 10,20 Create VLAN 10,20
DUT(config-vlan)#exit Exit VLAN database mode.
DUT(config)#interface eth-0-1 Enter the interface mode.
DUT(config-if)#switchport mode trunk Set the switching characteristics of this interface trunk
mode.
DUT(config-if)#switchport trunk allowed vlan all Set this trunk port allow all VLANs on this interface.
DUT(config-if)#switchport trunk native vlan 10 Set this trunk port’s PVID to 10.