CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 324)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 324 of 350
41 Configuring STM
Switch Table Management (STM) is used to configure system resources in the switch to
optimize support for specific features, depending on how the switch is used in the network.
You can select a template to provide maximum system usage for some functions; for example,
use the default template to balance resources. In this release, we only support default template.
41.1.1 References
41.1.2 Terminology
STM Configuration
You must reload the switch for the configuration to take effect.
DUT# configure terminal Enter the Configure mode.
DUT(config)# stm prefer default Specify default template used in the switch.
After the system reboots, you can use the command “show stm prefer” in privileged EXEC mode
to verify the new template configuration.
41.1.3 Validation Commands
This is an example of an output display for default template.
DUT#show stm prefer
[PROFILE INFO] OUT:
current profile is :default
following information is about selected default profile:
entry number of MAC ADDR : 24K
entry number of USER ID MAC ADDR : 4K
entry number of IPV4 MCAST ROUTE : 4K
entry number of IPV4 UCAST ROUTE : 32K
entry number of IPV6 UCAST ROUTE : 2K
entry number of ACL IPV4/MAC : 4K
entry number of QOS IPV4/MAC : 4K
entry number of USER ID IPV6 : 2K
entry number of USER ID IPV4 : 2K
entry number of ACL IPV6 : 2K
entry number of QOS IPV6 : 2K