CANOGA PERKINS CanogaOS Configuration Guide User Manual
Page 144
CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches
Page 144 of 350
DUT(config)#router bgp 100
Creat bgp 100 and enter the router mode
DUT(config-router)#bgp router-id 10.10.10.10
Configure the bgp router-id
DUT(config-router)#neighbor 11.11.11.11
remote-as 100
Configure the ibgp neighbor with as 100
DUT(config-router)#neighbor 11.11.11.11
update-source loopback 0
Configure the loopback 0 to be the update-source interface
DUT(config-router)#network 4.0.0.0/8
Network the specified route 4.0.0.0/8
DUT(config-router)#redistribute static
Redistribute the static route into bgp
DUT(config-router)#redistribute connected
Redistribute the connect route into bgp
DUT(config-router)#exit
Exit the router mode and enter the Configure mode.
18.3.3 Router B
DUT#configure terminal
Enter the Configure mode.
DUT(config)#interface eth-0-13
Specify the interface (eth-0-13)to be configured and enter the
Interface mode.
DUT (config-if)#no shutdown
Enable the interface.
DUT(config-if) # no switchport
Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 1.1.1.2/24
Configure IP address to 1.1.1.2/24.
DUT(config-if)#exit
Exit the Interface mode and enter the Configure mode.
DUT(config)#interface loopback 0
Specify the interface (loopback 0)to be configured and enter
the Interface mode.
DUT(config-if) # ip address 11.11.11.11/32
Configure IP address to 11.11.11.11/32.
DUT(config-if)#exit
Exit the Interface mode and enter the Configure mode.
DUT(config)# ip route 10.10.10.10/32 1.1.1.1
Add a static route 10.10.10.10/32 with nexthop 1.1.1.1
DUT(config)#router bgp 100
Creat bgp 100 and enter the router mode
DUT(config-router)#bgp router-id 11.11.11.11
Configure the bgp router-id
DUT(config-router)#neighbor 10.10.10.10
remote-as 100
Configure the ibgp neighbor with as 100