CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 216)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 216 of 350
27 Configuring BGP/MPLS VPN
Figure 1: BGP/MPLS VPN
27.1.1 Configuration steps
27.1.2 CE1(DUT1)
DUT#configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-9
Specify the interface (eth-0-9)to be configured and enter the
Interface mode.
DUT (config-if)#no shutdown Enable the interface.
DUT(config-if) # no switchport
Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 2.2.2.3/24
Configure IP address to 2.2.2.3/24.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)#interface eth-0-22
Specify the interface (eth-0-22)to be configured and enter the
Interface mode.
DUT (config-if)#no shutdown Enable the interface.
DUT(config-if) # no switchport
Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 8.8.8.2/24
Configure IP address to 8.8.8.2/24.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)# ip route 5.5.5.0/24 2.2.2.2 Add a static route 5.5.5.0/24 with nexthop 2.2.2.2
AS1
CE1 PE1 PE2 CE2 C
e-0-22 e-0-9 e-0-9 e-0-20
IBGP
e-0-20 e-0-9 e-0-9 e-0-1 eth62
8.8.8.2 2.2.2.3 2.2.2.2 1.1.1.3 1.1.1.2 5.5.5.5 5.5.5.3 9.9.9.8 9.9.9.3
VPN 100 VPN 100