CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 290)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 290 of 350
Configurations
ACL details
DUT#configure terminal Enter configuration mode
DUT (config)#mac access-list mac Define a MAC ACL and enter ACL
configuration mode
DUT(config-mac-acl)#permit src-mac host 1111.1111.1111
dest-mac any Config ACE to permit packet with source
mac address 1111.1111.1111
DUT(config-mac-acl)#deny src-mac any dest-mac any Config ACE to deny any packets.
DUT(config-mac-acl)#exit Exit ACL configuration mode
DUT(config)#ip access-list ipv4 Define a IPv4 ACL and enter ACL
configuration mode.
DUT(config-ip-acl)#permit any 1.1.1.1 0.0.0.255 any Config ACE to permit subnet 1.1.1.1/24
DUT(config-ip-acl)#deny any any any Config ACE to deny any packets.
DUT(config-ip-acl)#exit Exit ACL configuration mode.
DUT(config)#ipv6 access-list ipv6 Define a IPv6 ACL and enter ACL
configuration mode .
DUT(config-ipv6-acl)#permit udp any any Config ACE to permit UDP ipv6 packets.
DUT(config-ipv6-acl)#deny any any any Config ACE to deny any packets.
Interface details
DUT#configure terminal Enter configuration mode
DUT(config)#interface eth-0-1 Enter interface configuration mode
DUT(config-if)#mac access-group mac in Apply MAC ACL mac on interface with
ingress direction.
DUT(config-if)#interface eth-0-2 Enter interface configuration mode
DUT(config-if)#ip access-group ipv4 in Apply IPv4 ACL ipv4 on interface with
ingress direction.