CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 251)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 251 of 350
DUT1(config)#interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the
interface
DUT1(config-if)#mpls-l2-circuit vc1 Bind an interface to the
Virtual Circuit.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# router rip Enter the router-rip mode
DUT1(config-router)# network
10.10.10.10/32 Associate networks with
the RIP process.
DUT1(config-router)# network
2.2.2.0/24 Associate networks with
the RIP process.
DUT1(config-router)#exit Exit the router-rip mode.
DUT1(config)#mpls
enable-all-interfaces Enable label-switching on
all interfaces.
30.2.2 Configurations on PE2
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface
eth-0-12 Enter the Interface mode.
• eth-0-12—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#enable-ldp Configure Interface for LDP
DUT1(config-if)#ip address
2.2.2.2/24 Create IP address on the port.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)#interface
eth-0-17 Enter the Interface mode.
• eth-0-17—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#enable-ldp Configure Interface for LDP
DUT1(config-if)#ip address
3.3.3.1/24 Create IP address on the port.