CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 28)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 28 of 350
DUT2(config-if)# channel-group 1 mode active
Add this interface to channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT2(config-if)#no shutdown Enable the interface.
DUT2(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT2(config)#interface eth-0-3
Specify the interface (eth-0-3)to be configured and enter the
Interface mode.
DUT2(config-if)# channel-group 1 mode active
Add this interface to channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT2(config-if)#no shutdown Enable the interface.
DUT2(config-if)#end Return to privileged EXEC mode.
3.1.2 Validation Commands
DUT1# show channel-group summary
Flags: s - suspend I - stand-alone
D - down/admin down B - in Bundle
R - Layer3 S - Layer2
H - standby
w - wait U - in use
Aggregator Name Protocol Ports
----------------+------------+-----------------------------------------
agg1(SU) LACP eth-0-1(B) eth-0-2(B) eth-0-3(B)
DUT1# show interface agg1
Interface agg1
Interface current state: UP
Hardware is AGGREGATE, address is cce3.33fc.330b (bia cce3.33fc.330b)
Bandwidth 3000000 kbits
Index 1025 , Metric 1 , Encapsulation ARPA , loopback not set
Speed - 1000Mb/s , Duplex - Full , Media type is Aggregation
Link speed type is autonegotiation, Link duplex type is autonegotiation
Input flow-control is off, output flow-control is off
The Maximum Frame Size is 1534 bytes