CANOGA PERKINS CanogaOS Configuration Guide User Manual

Page 73

Advertising
background image

CanogaOS Configuration Guide

Proprietary & Confidential Canoga Perkins Metro Ethernet Switches

Page 73 of 350

trunk mode.

DUT(config-if)#switchport trunk allowed vlan add
11,12

Enable VLAN 11, 12 on this port.

DUT(config-vlan) # exit

Exit the interface mode and enter the Configure mode.


Configure interface eth-0-13

DUT(config) # interface eth-0-13

Enter the Interface mode.

DUT(config-if)#switchport mode trunk

Set the switching characteristics of this interface to
trunk mode.

DUT(config-if)#switchport trunk allowed vlan add 12

Enable VLAN 12 on this port.

DUT(config-vlan) # exit

Exit the interface mode and enter the Configure mode.


Configure and enable ERPS domain

DUT(config) # erps 1

Create erps domain with id 1.

DUT(config) # erps 1 primary control vlan 11

Set vlan 11 as the primary control vlan of erps domain
1.

DUT(config) # erps 1 ring 1 level primary

Create an erps primary ring 1 for domain 1.

DUT(config) # erps 1 ring 1 mode transit

Set node as transit of ring 1 for domain 1.

DUT(config) # erps 1 ring 1 primary interface eth-0-9

Set primary interface of ring 1 for domain 1.

DUT(config)# erps 1 ring 1 secondary interface eth-0-20 Set secondary interface of ring 1 for domain 1.

DUT(config) # erps 1 ring 1 enable

Enable ring 1 for domain 1.

DUT(config) # erps 1 enable

Enable domain 1.

DUT(config) # erps 2

Create erps domain with id 2.

DUT(config) # erps 2 primary control vlan 12

Set vlan 12 as the primary control vlan of erps domain
2.

DUT(config) # erps 2 ring 1 level primary

Create a erps primary ring 1 for domain 2.

DUT(config) # erps 2 ring 1 mode transit

Set node as transit of ring 1 for domain 2.

DUT(config) # erps 2 ring 1primary interface eth-0-13

Set primary interface of ring 1 for domain 2.

DUT(config)# erps 2 ring 1 secondary interface eth-0-20 Set secondary interface of ring 1 for domain 2.

DUT(config) # erps 2 ring 1 enable

Enable ring 1 for domain 2.

DUT(config) # erps 2 enable

Enable domain 2.


Switch 3
Create VLANs for transferring ERPS control packets

Advertising