CANOGA PERKINS CanogaOS Configuration Guide User Manual
Page 236
CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches
Page 236 of 350
come into the VPLS instance
mode.
DUT1(config-vpls)#vpls-peer 11.11.1.1
raw
Add a PE for VPLS instance.
DUT1(config-vpls)#vpls-peer 11.11.4.4
raw
Add a PE for VPLS instance.
DUT1(config-vpls)#exit
Exit VPLS instance mode.
DUT1(config)#interface eth-0-1
Enter the Interface mode
• eth-0-1—Specify the
interface
DUT1(config-if)#mpls-vpls v3
Bind an interface to a VPLS
instance.
DUT1(config-if)#exit
Exit the Interface mode.
DUT1(config)#interface eth-0-2
Enter the Interface mode
• eth-0-2—Specify the
interface
DUT1(config-if)#mpls-vpls v3
Bind an interface to a VPLS
instance.
DUT1(config-if)#exit
Exit the Interface mode.
Configuring the VPLS on P
Command
Description
DUT1#configure terminal
Enter the Configure mode.
DUT1(config)#interface eth-0-9
Enter the Interface mode.
• eth-0-9—Specify the
interface
DUT1(config)#no switchport
Configure the port to layer 3
port.
DUT1(config-if)#ip address
11.11.9.2/24
Create IP address on the port.
DUT1(config-if)#enable-ldp
Configure Interface for LDP