CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 194)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 194 of 350
DUT1(config-if)#no shutdown
DUT1(config-if)#ip address 4.4.4.1/24
DUT1(config-if)#exit
DUT1(config)#router rip
DUT1(config-router)#network 2.2.2.0/24
DUT1(config-router)#redistribute connected
DUT1(config-router)#end
DUT1#
(3) Configure Switch C
Switch C belongs to VPN2, Configuration the connection to switch D by using these commands.
DUT1>enable
DUT1#configure t
Enter configuration commands, one per line. End with CNTL/Z.
DUT1(config)#interface eth-0-9
DUT1(config-if)#no switchport
DUT1(config-if)#no shutdown
DUT1(config-if)#ip address 1.1.1.1/24
DUT1(config-if)#exit
DUT1(config)#interface eth-0-1
DUT1(config-if)#no switchport
DUT1(config-if)#no shutdown
DUT1(config-if)#ip address 3.3.3.1/24
DUT1(config-if)#exit
DUT1(config)#router rip
DUT1(config-router)#network 1.1.1.0/24
DUT1(config-router)#redistribute connected
DUT1(config-router)#end
(4) Configure Switch D
On Switch D, enable RIP and configure VRF
DUT1>enable