CANOGA PERKINS CanogaOS Configuration Guide User Manual
Page 174
CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches
Page 174 of 350
Switch A
eth-0-1 in vlan111, eth-0-2 in vlan10, and eth-0-3 vlan20
DUT# configure terminal
Enter the configure mode
DUT(config) # vlan database
Enter VLAN database mode
DUT(config-vlan) # vlan 111,10,30
Creat vlan 111,10,30
DUT(config-vlan) # quit
Quit the VLAN database mode and return to Configure
mode to configure the next interface.
DUT(config) # interface eth-0-1
Enter the Interface mode..
DUT(config-if) # switchport access vlan111
Enable VLAN port access by specifying the VLAN ID
111 on this interface.
DUT(config) # interface eth-0-2
Enter the Interface mode..
DUT(config-if) # switchport access vlan10
Enable VLAN port access by specifying the VLAN ID
10 on this interface.
DUT(config) # interface eth-0-3
Enter the Interface mode..
DUT(config-if) # switchport access vlan30
Enable VLAN port access by specifying the VLAN ID
30 on this interface.
DUT(config-if) # end
Return to privileged EXEC mode.
Eanble MVR in the switchA, it is required that only one copy of multicast traffic from Router A
is sent to switchA, but HostA and HostC can both receiver this multicast traffic.
DUT# configure terminal
Enter the configure mode
DUT(config) # no ip multicst-routing
Disable ip multicast-routing
DUT(config) # mvr
Enable Multicast Vlan Registration
DUT(config) # mvr vlan 111
Configure mvr vlan
DUT(config) # mvr group 238.255.0.1 255
Configure mvr group address
DUT(config) # mvr source-address 12.12.12.1
Configure mvr source-address
DUT(config) # interface eth-0-1
Enter the Interface mode..
DUT(config-if) # mvr type source
Configure the port to mvr type source.
DUT(config) # interface eth-0-2
Enter the Interface mode..
DUT(config-if) # mvr type receiver vlan 10
Configure the port to mvr type receiver.
DUT(config) # interface eth-0-3
Enter the Interface mode..
DUT(config-if) # mvr type receiver vlan 30
Configure the port to mvr type receiver.
DUT(config-if) # end
Return to privileged EXEC mode.