CANOGA PERKINS CanogaOS Configuration Guide User Manual

Page 62

Advertising
background image

CanogaOS Configuration Guide

Proprietary & Confidential Canoga Perkins Metro Ethernet Switches

Page 62 of 350

ERPS domain primary control VLAN ID: 15

ERPS domain sub control VLAN ID: 0

ERPS domain hello timer interval: 1 second(s)

ERPS domain fail timer interval: 3 second(s)

ERPS ring ID: 1

ERPS ring level: primary

ERPS ring 1 node mode: transit

ERPS ring 1 node state: link up

ERPS ring 1 primary interface name: eth-0-17

ERPS ring 1 secondary interface name: eth-0-13

9.1.3 Configuring a Single-Domain Intersecting-Ring Topology
Configure same ERPS domain at switch 1, switch 2, switch 3 and switch 4. Switch 1, switch 2
and switch 3 consist of ERPS primary ring 1 while switch 2, switch3 and switch 4 consist of
ERPS sub ring 2. Switch 1 is configured as ERPS ring 1 master node and other two switches are
configured as ERPS transit nodes while switch 4 is configured as ERPS ring 2 master node. In
addition switch 2 is configured as edge node and switch 3 is configured as assistant-edge node.
Note:
z

The ports accessing an ERPS ring must be configured as trunk ports, permitting the traffic of

data VLANs to pass through.

z

The ports accessing an ERPS ring must be configured as the members of the control VLAN,

allowing the ERPS packets to be sent and received.

z

STP on ports accessing ERPS rings must be disabled.

z

Only one primary ring is allowed to be configured for each domain.

z

The edge/assistant-edge node of the sub rings must be the intersecting nodes for two rings.

z

The edge/assistant-edge node of the sub rings must be transit node.

z

The common interface must be the intersecting interface for two rings.

z

The edge interface must belong to only one sub ring.

z

Primary and sub rings must only be coexisted in edge/assistant nodes.

z

Primary ring must be created and enabled prior to sub rings.

z

Sub rings must be disabled and removed before primary ring.

z

One switch can only work as master node for a ring and transit node for the other rings

within the same domain.

Advertising