CANOGA PERKINS CanogaOS Configuration Guide User Manual
Page 133
CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches
Page 133 of 350
17.9.2 Configurations
R1
DUT# configure terminal
Enter the Configure mode.
DUT(config)# router ospf 100
Configure the Routing process and specify the Process
ID (100). The Process ID should be a unique positive
integer identifying the routing process.
DUT(config-router)# network 10.10.10.0/24 area 0
DUT(config-router)# network 10.10.11.0/24 area 0
Define interfaces on which OSPF runs and associate the
area ID (0) with the interface (area ID 0 specifies the
backbone area).
DUT(config-router)# area 0 authentication
message-digest
Enable MD5 authentication on area 0.
DUT(config-router)# exit
Exit the Router mode and return to Configure mode.
DUT(config)# interface eth-0-1
Specify the interface (eth-0-1) to be configured.
DUT(config-if)# ip ospf message-digest-key 1 md5 test Register MD5 key test for OSPF authentication. The
Key ID is 1.
DUT(config-if)# exit
Exit the Interface mode and return to Configure mode
DUT(config)# interface eth-0-2
Specify the interface (eth-0-2) to be configured.
DUT(config-if)# ip ospf authentication
Enable OSPF packet to use text authentication on the
current interface (eth-0-2).
DUT(config-if)# ip ospf authentication-key test
Specify an OSPF authentication password test for the
neighboring routers.
R2
DUT# configure terminal
Enter the Configure mode.
DUT(config)# router ospf 100
Configure the Routing process and specify the Process
ID (100). The Process ID should be a unique positive
integer identifying the routing process.
DUT(config-router)# network 10.10.10.0/24 area 0
DUT(config-router)# network 10.10.11.0/24 area 0
Define interfaces on which OSPF runs and associate the
area ID (0) with the interface (area ID 0 specifies the
backbone area).
DUT(config-router)# area 0 authentication
message-digest
Enable MD5 authentication on area 0.
DUT(config-router)# exit
Exit the Router mode and return to Configure mode.
DUT(config)# interface eth-0-1
Specify the interface (eth-0-1) to be configured.