Subwoofer, Press standby/on on the remote control, Check the following points – Yamaha YSP-1100 User Manual
Page 103: O exp a, Press enter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Carry out the AUTO SETUP (IntelliBeam) procedure to adjust the settings that
best match your listening environment.
This unit employs the YAMAHA IntelliBeam technology with the aid of the supplied optimizer microphone, allowing you to achieve highly accurate sound adjustments
that best match your listening environment. Be advised that it is normal for loud test tones to be output during the AUTO SETUP procedure. Make sure that there are
no children around in the listening room while the AUTO SETUP procedure is in progress.
Press STANDBY/ON on
the remote control.
The power of this unit turns on.
If a subwoofer with adjustable volume and
crossover/high cut frequency controls is
connected to this unit, set the volume
between 11 and 1 o’clock as viewed on a
conventional clockface and set the
crossover/high cut frequency to the
Check the following points.
• Is the optimizer microphone firmly connected to this unit?
• Is the optimizer microphone placed In a proper loacation?
• Are there any large obstacles in between the optimizer microphone and the
walls in your listening room?
• The AUTO SETUP procedure starts in 10 seconds after pressing ENTER
on step 7. To achieve the best results possible, evacuate yourself for your
listening room until the AUTO SETUP procedure is completed.
• To cancel the AUTO SETUP procedure after it is started, press RETURN.
• The AUTO SETUP procedure takes about
Turn on the power of your TV.
o Select the appropriate video input
on your TV.
Press ENTER to start the AUTO SETUP procedure.
‘ ' The following screen appears on the TV and the AUTO SETUP procedure
starts in 10 seconds.
Set the operation mode selector to YSP.
Press and hold AUTO SETUP for more than 2
The menu screen appears on the TV.
If the menu screen does not appear, check the video pin cable (connection
(D in the diagram on the front page) is connected properly and then press
YSP followed by MENU.
ISTBj IVCRI tPVPl fAUXj
iNPUTt iNPUT2 MACRO
( 3 0 0 0
I VOL MOPE
o exp a
5BEAM sTif J
The setup screen automatically changes during the AUTO SETUP
If any error occurs, the corresponding error message appears on the screen.
In this case, see “Error messages for AUTO SETUP” on page 35 in the
Owner’s Manual and then follow the instructions. To start the AUTO SETUP
procedure once again, press RETURN and then carry out the procedure from
When the AUTO SETUP procedure is complete, the following screen
appears on the TV.
' This is an example of the result screen.
The result may differ depending on the
The result is confirmed and the following screen appears on the TV for 2
seconds and then the menu screen disappears from the TV.
The new settings are automatically saved in the system memory.
Disconnect the optimizer microphone and keep it in a safe place.