Esijli – Yamaha YSP-1100 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
AUTO SETUP (InternBeam)
Check that the following screen is displayed
on your TV.
The results of the AUTO SETUP procedure are
displayed on your TV.
10 Disconnect the optimizer microphone from
the OPTIMIZER MIC jack on the front panel.
BEAM MODE :5 BEAM
• If “ENVIRONMENT CHECK [FAILED]” is
displayed, we recommend running the AUTO SETUP
procedure again. For details, see step 9.
• If “SUBWOOFER : NOT APPLICABLE” is
displayed even though a subwoofer is connected to this
unit, increase the volume level of the subwoofer and
run the AUTO SETUP procedure again.
• Depending on the environment of your listening room,
the beam angle of front left and right, and surround left
and right may be set to the same value even if 5BEAM
is displayed as a result.
Press ENTER to confirm the results or press
RETURN to cancel the results.
The following screen is displayed temporarily for 2
seconds and then disappears from your TV.
AUTO SETUP COMPLETE
Please repioye the MIC fr-opi
the VSP and the listening
If ‘‘ENVIRONMENT CHECK [FAILED]” is displayed in
step 8, the following screen is displayed after pressing
ENTER. In this case, see ERROR E-1 in “Error messages
for AUTO SETUP” on page 35. Press ENTER to exit the
AUTO SETUP and then run the procedure again from