Beam menu, Setting parameters (setting parameters), Fiiseiil plfitflee 1/3 – Yamaha YSP-1100 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Use to manually adjust various parameters related to the
sound beam output.
SET MENU -> MANUAL SETUP ^ BEAM MENU
■ FDSETTIHa PARAMETERS
Select FLAT TO WALL if this unit is installed in
parallel with the wall in your listening room. Adjust the
width and length of your listening room as well as the
distance of the listening position from this unit and the
distance of the center of this unit from the left wall.
from the left wall
You can adjust the sound beam output level of each channel in
“ADJUSTING THE AUDIO BALANCE” (see page 72).
■ SETTING PARAMETERS
Use to set the position of this unit in your listening room
and the distance of this unit from the listening position.
When you make settings for each parameter, other related
parameters are automatically adjusted to best match your
If you make adjustments in SETTING PARAMETERS, the beam
optimization settings made in the AUTO SETUP procedure will
be lost. If you want to keep the beam optimization settings made
in the AUTO SETUP and make further adjustments, adjust
settings in BEAM ADJUSTMENT first (see page 63).
from the unit
Choices for the room width and length:
2.0 m to 12.0 m
Choices for the listening position from this unit:
1.8 m to 9.0 m
Choices for the listening position from the left wall:
0.6 m to 11.4 m
Room width and length
fiiSEIIl PlfitflEE 1/3
[jt]/[T]: Up/Down W] / [t>-]: Se 1
Listening position from the
unit and the left wall
2.7r'-i [ 2.5P-I ]
(Installed position of this unit)
Use to adjust the installed position of this unit.
FLAT TO WALL
(Parallel to wall installation),
ANGLE TO WALL OR CORNER
FLAT TO WALL
ANGLE TO WALL