Xerox 7042 - Manual (Page 130)

Maintenance Procedures
Error codes
The communication information code lists the results of each
facsimile communication. The messages and the codes are
either displayed in the LCD or they are printed in the lists and
reports.
If a code is not in this table, begin the operation again. If the
machine continues to display the error, contact your service
representative.
Table 10-4:
Communication Error Codes
Information
Code
Model
Descriptions and
Corrective Actions
OK The communication ended
normally.
STOP Communication was
stopped by pressing the
STOP key.
ND Transmit No document was loaded
to transmit. Load the
document to transmit.
PE G3/polling The paper cassette was
empty when the polling
function was selected.
001 Communication
disconnected because the
cover was opened.
002 Transmit The document jammed or
the document length is
greater than 1 m. Follow
the steps to clear a
document jam.
003 Receive The recording paper is
empty or jammed, or the
memory is too full to
receive the document.
005 Modem setting timed out or
a modem error occurred.
Begin the operation again.
If the table does not list the communication mode, the code applies to any operation.
10-8