Programming the dial directory – Xerox 7042 User Manual
Page 60
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming the Dial Directory
9.
Press the START key.
10.
Perform steps 6 through 9 for each number you want to
add to the group.
11. Press the START key. The LCD displays the group
name.
12.
Complete the following steps to change the group name
using the dial keys. Refer to the Character Codes table
for the keypad and character assignments.
NOTE: Each speed dial and one-touch key must have a
unique name.
a.
Press the control panel keypad number that
corresponds to the character you desire. The first
character displays.
b.
Press the keypad number repeatedly until the correct
character displays.
c.
To move to the next position, press the
#
(-^) key.
d.
Perform steps a through c for each character in the
name. You can enter up to 15 characters.
e.
Verify the group name you entered. To change a
character, move the cursor to that character, press
the CLEAR key, and reenter the character.
13. Press the START key to save the changes to the group.
14.
Press the STOP key. The machine goes to the standby
mode.
4-14