Aiwa HV-MX100U - Manual (Page 17)

SEARCH/INDEX
STO P
RESET
CD
DISPLAY
CD
P i c i y i n g f r a m o - b y - f r . i m o u s i n g t i u *
j o g d i a l
1 Press II PAUSE/STILL to pause the picture.
2
Spin the jog diai right (or ieft for reverse
playback) with your finger.
The playback speed varies according to the speed you
spin the jog diai.
' If you continue slow motion playback for more than 5
minutes, the VCR wili automaticaliy enter stop mode to
protect the tape.
’ The sound will be muted during various speed playback.
' With tapes recorded in PAL, SECAM, MESECAM or N-PAL
color systems at LP speed, the color fades during slow
motion playback or high speed playback.
R e w i n d i n g o r f c i s t - f o r \ v a r d i n g t o a
s p e c i f i c p o i n t — / c m K e t i i r n
1 Press COUNTER RESET at the point you want
to locate later.
The tape counter in the display window resets to
“ 0 : 00 : 00 .”
n. n n. n n
LI ■ LI LI ■ LI LI
2
After playback or recording, press ■ STOP,
then ZERO RETURN.
The tape automatically stops when the tape counter
returns to about “0:00:00.”
T o c a n c e l Z e r o R e t u r n
Press ■ STOP.
Tips
• You can also see the tape counter on the screen display.
Press COUNTER DISPLAY repeatedly until the tape counter
appears. (See page 24.)
• To play, eject and switch off automatically after tape counter
returns to about “0:00:00.” press ZERO RETURN then press
► PLAY, ± EJECT or POWER within 2 seconds.
' When you insert a cassette, the tape counter is reset to
“0:00:00.”
' The tape counter does not work while playing unrecorded
portions of tape.
S e a r c h i n g w i t h t h e i n d e x f u n c t i o n
— I n d e x S e a r c h
The VCR automatically marks an index signal on the tape
each time recording starts. “INDEX” flashes on the TV
screen while the VCR marks an index signal. You can use
these signals to find the beginning of any recording.
Press SEARCH/INDEX (for succeeding
programs) or SEARCH/INDEX (for preceding
programs) repeatedly during stop until the index
number (up to 20) you want appears on the TV
screen.
The VCR starts searching.
When the VCR detects the index number, playback starts
automatically from the beginning of the specified recording.
Index number
Tip
You can also use the display window to check the index number
you specified. “INDEX” and the index number will appear in the
display window when you press SEARCH/INDEX.
• Index signals should be at least 1 minute apart in SP mode,
2 minutes apart in LP mode, and 3 minutes apart in EP
mode. Otherwise, the VCR cannot detect them properly.
• Index signals may not be detected on damaged or worn out
tapes.
• Index signals may not be detected at the beginning of
recordings where the tape speed is different from the
previous program.
• The index signal at the beginning of a recorded tape may not
be detected.
• The index search indicator and index number do not appear
if the display mode is off.
ENGLISH 1 6