Setting the vcr channels, Before starting, 1 press menu – Aiwa HV-MX100U User Manual
Page 9: 3 press -4/^ to select usa, then press t, 4 press to select tv or catv, Press menu, Press, Press -4/^ to select usa, then press, Press to select tv or catv, Dd (d) ck)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To correct the digits while setting
Before pressing OK in step 5 on page 7, press ▲ to select
, the item you wish to correct. Reset the digits using
'Mps
• When the power supply is interrupted for more than 1 hour,
the clock setting is cleared. In this case, you have to set the
clock again.
• You can change the time indication from a 12 hour format to
a 24 hour format. See “Charging the VCR setup” on page 26.
• It you change the DAYLIGHT SAVING or hours and press
OK, the clock is not run. Change the minutes and press OK
and then the clock is beginning to run.
Setting the VCR channels
This convenient Channel Auto Set function can preset up to
125 channels in your area (VHP channels 2 to 13 and UHF
channels 14 to 69, or CATV channels 1 to 125).
Before starting
If the VCR is connected to a cable converter, make sure to
turn it on.
dD (d) CK)
1
Press MENU.
2
Press
A/T
to move the cursor (
f
) to
CHANNEL SET, then press ►.
1
PRO G RAM TIM EI
2
CLO CK SET
3
CO LO R SYSTEM
4
AUDIO SETUP
5
VCR SETUP
6
LANG UAG E
V
CHANNEL
SET
SELECT
;
PT»A
ENTER :[?►
END : P®
■ i
3
Press -4/^ to select USA, then press
T.
s^OUNTRY
’’% USA -JAPAN
BAND
•TV
• CATV
CHANNEL AUTO SET
CHANNEL M ANUAL SET
SELECT; PT*A
SET DATA; P^*^
END : P@
4
Press to select TV or CATV.
TV; the program from VHF/UHF antenna
CATV; the CATV according to the connections to the
AERIAL connector
CO UNTRY
.¿.•US A -JAPAN
■
a c p
BAND
^T^-TV «CATV
CHANNEL AUTO SET
CHANNEL M ANUAL SET
SELECT : PT-A
SET DATA; P^>
END : P®
CONTINUE
ENGLISH
8