Aiwa HV-MX100U - Manual (Page 7)

V C R r o c o p t i o n s o t t i I 1 J »
O
When a TV is connected with an antenna
cable only
When the TV is connected to the RF OUT using a supplied
antenna cable only, set TUNER #2 to 3 CH or 4 QH, not
employed for broadcasts, and select the same channel on
the TV.
To select a desired TV channel on the TV
Turn the TV and VCR then press TV/VCR to turn off “VCR”
in the display window, or turn off this VCR.
To see a TV program or video program selected on the
VCR
Turn the TV and VCR on, and press TVA/CR to display
“VCR” in the display window.
When a TV is connected with an audio/
video cable
When the TV is connected using an audio/video cable, set
TUNER #2 to CFF, then turn the TV and VCR on, and
select the video input mode on the TV.
Preparing the remote control
I n s e r t i n g t h e b a t t e r i e s
Insert the two supplied R6 (size AA) batteries.
Be sure to match O and © on the batteries to the diagram
inside the battery holder.
. • Do not mix a new battery with an old one.
• Do not mix different kinds of batteries.
• Remove the batteries when they have no more power, or
when you do not use the remote control for a long period of
time.
U s i n g I h o i v m o t c c o n t r o l
Point the remote control toward REMCTE SENSCR. * •
• The remote control may not operate when there is any
obstruction between the remote control and REMCTE
SENSOR.
• Strong ambient light sources such as a fluorescent lamp or
direct sunlight may cause unreliable operation.
• Using a TV with the same type of infrared remote control
facing the same direction may cause incorrect operation.
• The maximum distance for effective control between the
remote control and REMOTE SENSOR is 7 meters.
• Although you can use the remote control within an angle of
up to 30 degrees in any direction from directly in front of
REMOTE SENSOR, we recommend a narrower angle for
stable operation.
ENGLISH 6